캔음료 디스펜서(Can holder & Dispenser)

The project is cut into pieces so it is suitable for printing on a 200x200mm bed.
Update I've added another set of side walls that are divided into 3 parts so you can print on a 150x200mm bed.

You need to make two front walls and two rear walls (and two middle walls if using the 3 part walls) but one of each must be mirrored (so you have a left and a right of each).
You'll also need three top supports. As noted above, for deep fridges use the "with backwall" version of the "Walls rear" and print an extra top support (x4 rather than x3)

I first used PLA and it lasted 5 years, My latest is in PETG but I see no reason why ABS or PC shouldn't work just as well.

CHECK THE SIZE OF YOUR CANS! The shelves and supports are designed for 330ml cans (used in the UK) that are 115mm tall (and 66mm in diameter). If you're using taller cans, increase the 'X' scale on all cross pieces by the factor your cans are taller than 115.
For example, Australian cans are 375ml (130mm tall) so increase the length of all shelves, supports and stops by printing at about 114% on the X (or Y scale depending on how you've oriented your prints).

Levy4u comments that he successfully made a version for 16oz cans of "Monster Energy"
by scaling the width pieces to 138.25% (see photos in "Made" section").

Parts Required
Depending on which version you are making you will need different parts:

All versions need the cross pieces (scaled in the width dimension depending on can size):
1x Can_Holder_Shelf_lower_front.stl
1x Can_Holder_Shelf_lower_rear.stl
1x Can_Holder_Shelf_middle_front.stl
1x Can_Holder_Shelf_middle_rear.stl
3x Can_Holder_Supports_top_x3.stl
1x Can_Holder_front_support
1x Can_Holder_front_stop.stl
1x Can_Holder_Support_rear.stl

Then select from one of the three options, below:

For a shallow fridge (utilising the fridge's back wall):
2x Can_Holder_Walls_rear_x2.stl (print one as a mirrored or you'll have two right walls)
2x Can_Holder_Walls_front_x2.stl (one must be mirrored)

For a deep fridge (freestanding can holder):
2x Can_Holder_Walls_rear_with_backstop_x2.stl (one must be mirrored)
2x Can_Holder_Walls_front_x2.stl (one must be mirrored)
1x Can_Holder_Supports_top_x3.stl

For printing on a small printer (shallow fridge):
2x Can_Holder_3_part_walls_front_x2.stl (one must be mirrored)
2x Can_Holder_3_part_walls_middle_x2.stl (one must be mirrored)
2x Can_Holder_3_part_walls_rear_x2.stl (one must be mirrored)