필라멘트 용접기(Filament Welder)

출처 https://www.thingiverse.com/thing:5505014

Summary

A jig for welding 1.75mm PLA filament.

Welded filament slides smoothly through 2mm inner diameter tubing without sanding.

A PTFE tube and coil spring are required separately.

-PTFE tube: Length: 40mm, ID x OD: 1.8mm x 2.6mm

-Coil spring: Wire Diameter: 0.3mm; Outer Diameter: 3.4mm

How to use

">

This welder is designed to join the last filament of a roll to a new roll.

When using this welder, remove the filament from the printer, connect it to a new roll, wind it up, and re-insert it into the printer.

WELDING TIPS

(1) Insert two filaments into a doughnut-shaped jig and butt them in the center.

(2) Heat each side for about 1 second.

(3) Lightly push in the two filaments.

(4) After waiting for about 5 seconds, sandwich the center of the doughnut with two coin-shaped jigs.

(5) Gently push out the filament until the weld comes out.

(6) Done.

Print Settings

Rafts:

No

Supports:

No

Resolution:

0.15 mm

Infill:

50 %

Filament brand:

TINMORRY

Filament material:

PLA