권총 피젯(Revolver Fidget)

sniii · 2024-03-07 09:17 · 조회 155 · 피규어/토이

작업프로그램

기타(etc)

라이선스

CC BY-SA(저작자표시-동일조건변경허락)

제작여부

출처에서 가져옴

출처

싱기버스

기타

by fifonik

조회수

155

다운로드

파일명

Revolver-Fidget-Remix-6478943.zip

상세정보

출처: https://www.thingiverse.com/thing:6478943

Summary

I've re-made the revolver based on original EDUNBR3D's design implementing some changes for easier printing.

Changes from original:

All parts were re-modelled with some improvements;
A way the drum is attached to body is changed (it is more reliable);
Made some changes for easier printing (require less supports);
STEP files included.

I sliced in OrcaSlicer from STEP files using tree/organic supports.
You can see my support parameters on included pictures.
Notice, I adjusted threshold angle to 30 degrees (my printer can do this) and increased first layer expansion for organic supports. Without the last change the handle most probably will break while printing in 100%.
No support needed for drum, bullet and pin.

Printed on Elegoo Neptune 4 with 0.4mm nozzle using 0.2mm layer height in 100% and 150% sizes. I prefer bigger one as 100% is too small for me (it is ~82mm in length).

To check gaps/fittings I'd recommend you to pring drum and pivot first.
If yoo lose/tight and you use OrcaSlicer -- you can make adjustments using option "X-Y hole compensation" (I printed without changing the option, however my printer is quite good calibrated).
If pin is too lose -- just scale it up a little.

Assembling: insert pivot into drum, insert the pivot with drum into body and fix it with pin.

Demo and assembling: " rel="nofollow">

21 Feb 2024: Uploaded bullet's model as separate files.

Print Settings

Printer brand:

ELEGOO
Printer:

ELEGOO NEPTUNE 4
Supports:
Yes
Resolution:
0.2mm
Infill:
15-20%
Filament brand:

Any
Filament color:

Any
Filament material:

PLA/PLA+