미니서랍(Under Desk Drawer)

sniii · 2023-07-13 15:16 · 조회 465 · 생활용품

작업프로그램

기타(etc)

라이선스

CC BY(저작자표시)

제작여부

출처에서 가져옴

출처

싱기버스

기타

by zahader

조회수

465

다운로드

파일명

Under_Desk_Drawer_6096695.zip

상세정보

출처: https://www.thingiverse.com/thing:6096695

Summary

My little Under desk drawer! It has dimensions of 140x200x40 mm (WLD). It perfectly fits scissors, pencils, pens, etc.

It is easy to print, and takes about 300 grams of plastic. no supports are needed when printing. I used a line thickness of 0.5mm and 0.3 layer height to print faster

The drawer is attached to the table with two screws. To do this, there are two large holes (12 mm) in the case so that you can get in with a screwdriver.

The facade is inserted into the drawer and glued. The handle is attached with a M3 screw or you can simply glue it.

I recommend exposing the seam to the side that is attached to the table when printing the main body. This is necessary so that the seam does not interfere with opening the drawer.

I also used transparent scotch tape to improve drawer sliding.

There is another smaller hole on the upper part of the main body. It serves to install the screw as a limiter so that the drawer does not fall out. The screw should be with a countersunk head and not be very long so that the drawer can be installed.

I'm not sure how the Drawer will work when printing ABS. There may be problems due to shrinkage.

This is my first project, I will be glad to get feedback:)

Print Settings

Printer:

Flying Bear Reborn

Rafts:

Doesn't Matter

Supports:

Resolution:

0.3

Infill:

Filament brand:

Syntech

Filament color:

Gray

Filament material:

PETG

Notes:

Used 0.5 Wall line wight. Took about 300 grams.