필라멘트 용접기(Filament Welder)
출처 https://www.thingiverse.com/thing:5505014
Summary
A jig for welding 1.75mm PLA filament.
Welded filament slides smoothly through 2mm inner diameter tubing without sanding.
A PTFE tube and coil spring are required separately.
-PTFE tube: Length: 40mm, ID x OD: 1.8mm x 2.6mm
-Coil spring: Wire Diameter: 0.3mm; Outer Diameter: 3.4mm
How to use
This welder is designed to join the last filament of a roll to a new roll.
When using this welder, remove the filament from the printer, connect it to a new roll, wind it up, and re-insert it into the printer.
WELDING TIPS
(1) Insert two filaments into a doughnut-shaped jig and butt them in the center.
(2) Heat each side for about 1 second.
(3) Lightly push in the two filaments.
(4) After waiting for about 5 seconds, sandwich the center of the doughnut with two coin-shaped jigs.
(5) Gently push out the filament until the weld comes out.
(6) Done.
Print Settings
Rafts:
No
Supports:
No
Resolution:
0.15 mm
Infill:
50 %
Filament brand:
TINMORRY
Filament material:
PLA