탁상용 진공청소기 노즐[Vaccum Nozzles (Desk-Cleaner and extra long Tube)]
살림남
·
2023-02-10 10:24 ·
조회 439 ·
생활용품
조회수
439
다운로드
1
파일명
Vaccum_Nozzles__Desk-Cleaner_and_extra_long_Tube__5800638.zip
상세정보
출처: https://www.thingiverse.com/thing:5800638
Summary
Yet another set of vacuum nozzles for 35mm adapters (most common in Europe) as I couldn't find suitable models on Thingiverse.
Number one is a "Desk Cleaner", i.e. it was designed to remove dust from areas where a normal vacuum nozzle is way to dangerous and may "swallow" unwanted parts lying on a cluttered desk, workbench or similar.
The other two are just long nozzles to get into niches, etc. The extra long version has a tube of 30cm and for those who don't have a printer that can print that height, there is another version with only 20cm tube.
Both types of adapters come with an optional head cap, recommended to be printed in TPU or any other soft material. They serve two purposes: first of all the soft material doesn't produce scratches on delicate surfaces. And second they avoid that especially the long nozzles suck themselves to a surface sheet of paper, etc. The TPU head for the long nozzles is designed like a "crown", making sure that there is always some hole for air to get in. Similar effect is achieved for the desk cleaner by some little nipples. (in the latest version the desk cleaner itself has small nipples already). And a third benefit: If the little crown gets worn over time, just replace the crown, don't print the compete nozzle again.
The TPU caps have very thin bases and need some support to be printed properly. Therefore I added models that have support and little adhesion pads already built in, to minimize wasted material. This support can be peeled off easily after print. The plain version without support are also included, but not really recommended to print as is.
This model is also available on printables.com, id 375673
Print Settings
Printer brand:
Creality
Creality
Printer:
CR-10S
CR-10S
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
20% (doesn't really matter)
Filament brand:
Sunlu
Sunlu
Filament color:
black and grey
black and grey
Filament material:
PLA for nozzles, TPU for caps
PLA for nozzles, TPU for caps
Notes:
Print nozzles standing upright and add a brim (or at least "mouse ears" (Tab Anti Warping plugin in Cura)) to fix the narrow base to the print bed. No support needed here.
For the caps I recommend to use the versions with built-in support. Other support than the built-in is not needed. Also brim should not be necessary for caps (some small adhesion helpers included in support - worked for me, give it a try)
Print nozzles standing upright and add a brim (or at least "mouse ears" (Tab Anti Warping plugin in Cura)) to fix the narrow base to the print bed. No support needed here.
For the caps I recommend to use the versions with built-in support. Other support than the built-in is not needed. Also brim should not be necessary for caps (some small adhesion helpers included in support - worked for me, give it a try)